HYP30-40

Speed (Capacity):

≥ 140 blanks per minute at < 50 mm (length)

≥ 120 blanks per minute at < 75 mm (length)

Length Tolerance

≤ ±0.12 mm at blank length of 50 mm

Single Feed :

Maximum 600 mm

Length Adjustment:

From operator panel

Cut-off tools:

1 pair of dies per cross-section and profile

Grippers:

1 set (2 pair of grippers)

Inlet Guide:

1 set per cross-section and profile

Brakes: (bar feed only)

1 set per cross-section and profile

Time for tool change :

Approximately 15 minutes

Control and supervision of:

• Number of blanks made

• Order complete

• Lack of material

• Oil temp/pressure/level

• Alarm indication

• Start-stop of the hydraulic pump

   

• Auto/man mode

   

• Emergency stop

   

Cutting unit:

Width: 2400 mm

Length: 3600 mm

Height: 3790 mm

Centerline, cutoff:

Height: 1500 mm

Hydropulsor HYP30-40

Approx. 11000 kg

Voltage:

Power requirements total:

53 kW max

Air-pressure:

0.1 m3/min at pressure 6 bar

Water cooler:

60 l/min at pressure 3-4 bar

Pressure:

180 bar

Power:

48 kW max (intermittent duty)

Flow rates:

150 l/min

Tank:

Approx 400 l

• Sound insulation

• Air cooler instead of water cooler for hydraulics

• Telephone modem for remote machine supervision

• Measurement system

  - HYP3001: General measuring system for machine parameters.

  - HYP3002: Performance and supervision.

• Bar magazine for diameter 3 – 40 mm

• Roller straightener

• Pay-off reel with or without power

Anti-vibrators:

Part of delivery (standard?)

Colour, standard:

Green and black

(or customer order)